LS-S3328TP-PWR-EI Specification |
| Fixed port | 24*10/100Base-T ports, 2* 100/1000Base-X and 2*1000Base-X ports |
| Processor | Dominant frequency: 300 MHz |
| Switching capacity | 12.8 Gbit/s |
| Forwarding performance | 9.6 Mpps |
| DDR memory | 128 MB |
| Flash Memory | 16 MB |
| Backplane switching capacity | 64 Gbit/s |
| MAC address table | Supports 16K MAC address entries. |
| Supports automatic learning and aging of MAC address. |
| Supports static, dynamic, and blackhole MAC address entries. |
| Supports packet filtering based on source MAC addresses. |
| VLAN features | Supports up to 4096 VLANs. |
| Supports guest VLANs,voice VLANs, and super VLANs. |
| Supports VLAN assignment based on MAC addresses, protocols, and IP subnets. |
| Supports basic QinQ and selective QinQ. |
| Supports 1:1 VLAN switching. |
| Supports N:1 VLAN switching. |
| QoS/ACL | Supports rate limit on packets sent and recieved by a port. |
| Supports packet redirection. |
| Supports port-based traffic policing and two-rate three-color CAR. |
| Supports multiple queue scheduling algorithms including WRR, DRR, SP, WRR+SP, and DRR+SP. |
| Supports re-marking of the 802.1p priority and DSCP priority. |
| Supports packet filtering based on Layer 2 to Layer 4 information, filtering out invalidframes based on the source MAC address, destination MACaddress,source IP address,destination IP address, port number, protocol, and VLAN ID. |
| Supports queue-based rate limit and traffic shaping on ports. |
| Supports eight queues on each port. |
| IPv6 features | Supports PMTU. |
| Supports Neighbor Discovery (ND). |
| Supports IPv6 Ping, IPv6 Tracert, and IPv6 Telnet. |
| Supports manually configured tunnels. |
| Supports 6-to-4 tunnels. |
| Supports ISATAP tunnels. |
| Supports ACLs based on the source IPv6 address, destination IPv6 address, Layer-4 port,or protocol type. |
| Supports MLD v1/v2 snooping. |
